Diy Gutter Hangars

Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the hole in the side.

Diy gutter hangars.

The hangers are designed to slip over the back edge of the gutter. Repeat threading up through the bottom hole and out through the side hole on the next two left gutter sections. Home centers sell a gutter apron in 10 ft. The gutter apron will prevent you from slipping the hangers over the back edge of the gutter as intended.

Without the correct support the rain gutters will sag. Gutters that are too high can enable runoff water to drip down their back side which in turn can cause deteriorating fascia boards and stains on siding. Once the apron s in place fasten it with sheet metal screws. All gutters are attached to your house by mounting system or different types of hangers inside outside or strap and the hangers need to be carefully spaced close together 3 feet or less to give the gutter proper support.

With help lift the gutter in place and secure the corner first screwing the bracket into the roof s fascia. Tip the hooked end of the bracket under the front flange and press the remaining end over the back fo the gutter. You may have to temporarily remove your hangers as you go or you can notch out the apron around them. A gutter apron is a bent piece of flashing that tucks up under the shingles and over the gutter.

Mistake 3 improperly spacing mounting or hanger system. With all the necessary fittings attached to this length of gutter install a hanger bracket every 2 to 3 ft.